Laying the rail tie plate, place the rail tie plate in the middle of the bearing rail surface, and the flange of the rail tie paltes should buckle the bearing rail surface.
Install the gauge baffle, respectively install the gauge baffle on the outside and the inside of the steel rail, and place it between the two ears of the rail tie plate. Do not press the rail tie plate. Check the gauge direction. If there is any discomfort, replace the gauge. Bezel. Due to the manufacturing deviation of steel rails, sleepers and gauge baffles, the gauge baffle of the specified number is installed, which cannot meet the gauge requirements or the gauge baffle cannot be installed in place, it can be replaced according to the actual situation. It is important to pay special attention to the fact that the gauge baffle should not be pressed against the rail tie plates; when installing the gauge baffle, do not violently knock the gauge baffle into place.
Install the rail clip, place the rail clip in place, put a flat washer on the rail screw spikes and coat the threaded part with railway-specific protective grease, then screw in the railway dowel to tighten the rail clip. The fastening of the rail clip is based on the contact between the lower jaw of the front end of the rail clip and the steel rail. The criterion for judging whether the rail clip is installed in place is that the lower jaw of the front end of the rail clip is in contact with the steel rail, and the gap is not more than 0.5mm.
This is the installation sequence of Rail Fastening System. I hope this information can provide you with some help. Of course, after installing the Rail Fastening System in this order, in order to ensure the installation effect of the Rail Fastening System, it needs to be adjusted appropriately, such as adjusting the gauge and direction, and adjusting the height of the steel rail.